SkyLink SA-001S Manual de usuario

Model: SA-001S User’s InstructionsWireless External Alarm

9- You will hear 1 beep and the LEDs will ash once indicating the Wireless External Alarm is being counted to Away mode.- After 30 seconds, you wil

10The Wireless External Alarm is designed to work with the Skylink security control panel such as AM-001, ML-001 and SC-001. Put the control panel tha

11You may connect your existing alarm system with the Wireless External Alarm so that the Wireless External Alarm will be triggered by your alarm syst

12You can enable or disable the Alert Notication. When it is set to enable, the Wireless External Alarm will beep when arm or disarm or during the en

13When the battery power is being reduced, the Wireless External Alarm will emit 3 beeps when the remote arm or disarm the unit. It is time to replace

14Your Wireless External Alarm requires few simple maintenance to ensure its con-tinued reliability and operation.- The solar panel on the top housing

15Questions SolutionsWhy the Wireless External Alarm does not respond to the sensors or remote?You must program the sensors or remote to the Wireless

16FccThis device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful in

17WArrANTyIf, within one year from date of purchase, this product should become defective(except battery), due to faulty workmanship or materials, it

18cusTOmEr sErVIcEIf you would like to - nd out the up-to-date specications - know more about features and applications - download documents, i.

1TABLE OF cONTENTINTRODUCTION...INSTALLATION...

19101Y035DEC,2012

2INTrOducTIONCongratulations on purchasing the Skylink Wireless External Alarm SA-001 Series. The SA-001 Series provide you with a piercing siren and

3- Set Compatibility Jumper:Refer to the following table to setup the Wireless External Alarm to work with different Skylink’s Security System or

4cAuTION:The adaptor as a disconnect devices: − the socket-outlet shall be installed near the equipment and shall be easily accessible. In order for t

53B – Learn motion sensor to the Wireless External Alarm:- Press and hold the Learn button on the Wireless External Alarm for 2 seconds and then rel

6Mutebutton3C – Learn door/window sensor to the Wireless External Alarm:- Press and hold the Learn button on the Wireless External Alarm for 2 seconds

7To erase unwanted remote(s) or sensor(s) or control panel(s) from the Wireless External Alarm will erase all learned devices from the Wire

8The Wireless External Alarm can be programmed to react 2 arming sequences when it receives the signal from the sensor. In order to arm the